News & Analysis
/
Article

Experimental characterization of eddy-current damping in a scanning tunneling microscope

NOV 20, 2026
Eddy-current damping effectively reduces mechanical vibrations in STM instruments, but its damping coefficient has received limited experimental characterization.
Experimental characterization of eddy-current damping in a scanning tunneling microscope internal name

Experimental characterization of eddy-current damping in a scanning tunneling microscope lead image

Scanning tunnelling microscopes (STMs) are one of the most powerful tools for analyzing material surfaces at the atomic level. This incredible resolution means the microscopes must be mechanically damped to minimize vibrations. However, previous studies of eddy-current damping in STM systems have primarily relied on theoretical models, with limited experimental characterization of the damping coefficient.

Villagomez et al. developed and experimentally validated a measurement apparatus to determine the eddy-current damping coefficient of an STM. They also expanded a mechanical model of the STM to describe its dynamics.

Eddy-current damping works by placing a metallic plate near a magnet. Relative motion between the plate and the magnet induces eddy currents in the plate, which generates a damping force opposing the direction of motion.

The authors measured this motion by directing a laser at a camera sensor which was partially obscured by the microscope’s base plate. As the microscope moves, the laser illuminates different regions of the sensor, allowing the researchers to measure the oscillations and determine the damping coefficient.

“By experimentally determining the damping coefficient, we can quantitatively evaluate the effectiveness of the damping system under different operating conditions and compare its performance with theoretical predictions,” said author Carlos Javier Villagomez. “This provides a more reliable approach to characterizing and optimizing vibration damping in STM instruments, rather than relying solely on theoretical calculations.”

In the future, the authors aim to correlate mechanical vibrations in the STM with noise in the acquired images to better understand their effects on STM measurements and potentially improve image quality.

Source: “Modeling the eddy current damping of a typical room- and low-temperature scanning tunneling microscope,” by Carlos Javier Villagómez, Bernardo Fuentes, Juan Adrián Reyes, Xavier Bouju, and Marco Antonio Sánchez-Alejo, Journal of Vacuum Science & Technology B (2026). The article can be accessed at https://doi.org/10.1116/5.0336009 .

This paper is part of the Surfaces, Thin Films, and Applications of Vacuum Technology at Mexican Institutions Collection, learn more here .

More Science
/
Article
Replacing rubidium with potassium improved low-frequency detection in Rydberg sensors.
/
Article
New work bridges the gap between single-photon measurements and high-sensitivity optical power meters.
/
Article
Researchers link center of gravity, tail posture, and aerodynamic performance, uncovering principles that could improve drone maneuverability.
/
Article
Ultrashort laser pulses can cause retinal lesions at energy levels deemed safe by the American National Standards Institute, and researchers are calling for a change.